home *** CD-ROM | disk | FTP | other *** search
- ****** Information for custom setting the driver ******
- ****** for the Double Speed SONY CDU31A series. ******
-
- To install device driver in config.sys:
-
- device=slcd.sys /B:xxx /d:mscd000 /v /c /m:x /t:x /k /n
-
- /B: Base port address of host adapter. 340H is the default.
-
- /d: Specifies device driver name. Used by MSCDEX. This is the
- current value if none is specified in config.sys.
- /v Turns on verbose mode of the driver. Driver displays
- information about its installation.
- /c Turns on displaying of drive configuration at boot time.
-
- /m: Data transfer mode: p = polled I/O, d = DMA, which requires
- the /t:x parameter.
-
- /t: Specifies the DMA channel to use if DMA transfer mode is
- selected.
-
- /k Enables a sector caching mechanism to improve the performance.
- The default is off.
- /n /2 specifies the double speed mode. /1 specifies the single
- speed mode. The default is the double speed mode.
-
-
- lastdrive=z
-
- Last valid drive letter. DOS defaults to 'e'. If you have 3 or more
- hard disks, or ram disks, this must be used to expand the number of
- letters available.
-
- To install Microsoft CD-ROM Extentions via autoexec.bat:
-
- mscdex /d:mscd000 /l:m
-
- /d: Name of CD-ROM device driver. Must match the value specified
- in config.sys. This is the name recommended by Microsoft.
-
- /l: Specifies the drive letter to use for the CD-ROM. If this,
- '/l:m' is not here, the next available drive letter is used.